Idiomas disponibles
Idiomas disponibles
3.
Method of setting guide plate
Loosen the knurled screw of the guide plate of each kind of the paper roll core size, set the set position, then fix the knurled screw.
1 is default position. (The following chart is a position where the core of one-inch diameter is set.)
1
: Position for 1.0 inch core size
1.5 : Position for 1.5 inch core size
2
: Position for 2.0 inch core size
3
: Position for 3.0 inch core size
4.
Method of setting paper roll
(1) The paper roll shaft of accessory parts is inserted in the paper roll, and it installs it in the paper roll unit.
Paper roll shaft
Note : 1. To load a new paper roll, first remove the tape and the glued portion at the beginning of the roll.
2. The printer cannot print on the glued portion of the paper, so remove about one turn of the paper roll from the
beginning. Any adhesive or other matter remaining from the glue may stick to the thermal head and cause a problem
such as voids on printouts. For this reason, be sure to remove the glued portion of the paper.
3. There is a direction of the installation when the paper is installed. Please install it like the clause 4- (3).
(2) Set the paper width by positioning the partition in the paper roll unit.
(1) Position the paper roll so that it is flush with the line indicated by arrow A.
(2) Loosen the knurled screw securing the front and rear partitions.
(3) Slide the partition in the direction of arrow B as appropriate to match the paper roll width.
(4) Fix the partition to leave a little space as shown in the diagram below
Front :Keep a space of one scale in the scale label between the paper roll and partition. Fix the partition to tighten the front
knurled screw.
Rear : Keep a space of 1 to 3 mm between the paper roll and partition. Fix the partition to tighten the front knurled screw.
Screw
Partitions
(Front)
_
Front
Knurled screw of guide plate
Paper roll
Paper roll shaft
Paper roll
Screw
(Rear)
_
Rear
_
Guide plate
Front side
Partitions
Rear side
3
2
1.5
1
Partitions
Paper roll
