Idiomas disponibles
Idiomas disponibles
(4) Connect the printer to the paper roll unit.
Insert the left and right connection flanges of the paper roll unit into the left and right holes of the printer connection bracket.
(5) Wire the sensor cable, interface cable, and AC adapter cable of the paper roll unit through the cable clamps from the inside to the
outside of the paper roll unit as shown in the diagram below.
Note :
The cable clamping opens pushing part A in the
direction of the arrow as shown in a right picture.
It wires for the cable as shown in figure. The core
is stored in the unit.
(6) The sensor cable of the paper roll unit fixes extra length of the sensor cable by clamping the cable between the printer side and the
paper roll unit as shown in the figure below because it is extra long.
2.
Method of setting PNE sensor
Select PNE sensor position by each size of paper roll core diameter, then pinch and fix the screw.
1 is default position. (The following chart is a position where the paper tube of one-inch diameter is set.)
1
: Position for 1.0 inch core size
1.5 : Position for 1.5 inch core size
2
: Position for 2.0 inch core size
3
: Position for 3.0 inch core size
Left and right holes of printer
connection bracket
Interface cable
Part A
Core
Sensor cable
Sensor cable
Left and right
connection flanges
of paper roll unit
Cable clamping
Extra length of
cable
Cable clamping
Cable clamping
1
1.5
____________
_
Screw
_PNE sensor
AC adapter
cable
Sensor
cable
2
3
