Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4. HELP

I cannot pair my mobile phone to the telephone base
• Make sure the Bluetooth function of your Bluetooth enabled mobile phone is turned on.
See the User's Guide of your mobile phone for more information.
• Make sure the handset, base unit and mobile phone are located near each other.
• Remove the Motorola L701BT, L702BT, L703BT, L704BT, L705BT from your mobile
phone's Bluetooth device history list (see the User's Guide of your mobile phone for
more information).
• Carefully follow the pairing instructions in the User's Guide, make sure that your mobile
phone is not connected to any other Bluetooth device(s).
• Turn off your mobile phone, and then turn it on again.
• Reset the telephone base. Unplug the unit's electrical power. Wait for approximately 15
seconds, and then plug it back in. Repeat the above suggestions.
The
icon is not scrolling when the handset is placed on the base
• Handset not properly seated on the base cradle - re-adjust the handset on the base.
• Dirty contact - clean the charge contacts by wiping with an alcohol moistened cloth.
• Battery is full - charging is not necessary at this time.
No dial tone
• If there is no base power, check the connections. Reset the phone by unplugging then
plugging it back into an electrical outlet.
• If the handset batteries are empty, recharge the battery pack for at least 24 hours.
• Move the handset closer to the base.
• Be sure to use only the provided telephone cords.
Poor audio quality
• If the base is too close to electrical appliances, reinforced concrete walls, or metal door
frames, move the base from these areas.
No ring tone
• The ringer may be off.
• The volume may need to be increased.
Caller ID does not work
• Check your subscription with your network operator.
• If you subscribe to high-speed internet service (Digital Subscriber Line - DSL) through your
telephone lines, you must install a DSL filter between the telephone base and the telephone
wall jack. The filter will prevent noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more information about DSL filters.
A phonebook entry cannot be stored
• The phonebook is full. Delete an entry to free memory.
No display
• Try recharging or replacing the rechargeable battery pack.
• Reset the base. Unplug the unit's electrical, then plug it back in.
• If the LED is not lit up, then try to unplug the unit's electrical power, and then plug it back
in.
HELP
29

Hide quick links:

Tabla de contenido
loading

Este manual también es adecuado para:

L702btL703btL704btL705bt

Tabla de contenido