Cardin TXQ504C2 Manual Del Usuario página 20

Setting a language:
Press a key to reach menu 7, press
keys and then press
Input/channel information:
1234:A--- [ 3G]
The letters A,B,C,D, indicate the status of the outputs CHA, CHB, CHC, CHD. If a letter is shown the output
is active while if a hyphen '-' appears in its place the output is inactive. If no strip is inserted the indications
will be replaced by an empty space.
Setting the relays
The receiver uses an "ON/OFF" channel relay that maintains the status even in the absence of power. The
relay can be set to 'impulsive' or 'timer' using the SET STRIP menu. Each channel is independent and
can be set at will. To set the strips press a
keys choose the channel A-B-C-D you wish to set and then press
the keys choose the setting you wish to modify and press
parameter the current setting will be shown. For each channel you may set the mode, contact type and
power on reset parameters.
The MODE parameters define the function type the relay will use. Using the
options and choose from: ON/OFF, IMPULSIVE, TIMER. Confirm the choice by pressing
mode will be made active immediately. If you choose "timer" you will be taken to a submenu in order to set
the relay activation time (from 1 to 255 seconds). Using the
to confirm.
ENT
The CONTACT TYPE parameters define the type of contact that will be associated with the relay when it is
at rest. Using the
NC. Confirm the choice by pressing
The POWER ON RESET parameters establish whether the relay will maintain the status when the receiver
is powered up or whether it will have to be reset and forced into the deactivated condition. Using the
keys scroll through the options and choose from: RESET ENABLED and RESET DISABLED. Confirm the
choice by pressing
ENT
TRANSMITTER CODE MANAGEMENT
Attention! Before memorising the transmitters for the first time remember to cancel the entire memory content.
Memorising a channel
• Scroll to menu "1) MEMORIZE TX", press
• Press the channel on the transmitter you wish to memorize, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the
display followed by one of the following:
- the symbol '+' indicates that a channel has been added;
P 1
200000001
SN
the symbol '=' indicates that the channel already exists
-
P 1
SN 200000001
Note:
(1)
you cannot memorize a transmitter that has already been memorised: in this case the symbol '=' will
appear on the LCD display.
(2) when the memory is completely full, the buzzer will sound 5 "beeps" one after the other and the indica-
tion "E03- memory full" will appear on the display.
ENT
again (the default language is Italian).
ENT
The numbers 1,2,3,4, indicate the status of the inputs IN1..4. If a number appears
on the display, this means that the input is 'high' or 'open' while if a hyphen appears
on the display the input is 'low' or 'closed'.
keys scroll through the options and choose from: CONTACT NO and CONTACT
and the mode will be made active immediately.
ENT
and the mode will be made active immediately.
ENT
, choose one of the five available languages using the
key to reach menu 5 and then press
ENT
keys choose the desired time and press
and "Activation 1" will appear on the LCD display;
(2)
(1) (2)
20
. Using the
ENT
to access the settings. Using
ENT
to confirm. When you access a
keys, scroll through the
ENT
.
and the