Tabla de contenido
C O N N E C T I N G R E F R I G E R A T O R A N D F R E E Z E R A N D P R E P A R I N G
IMPORTANT! We RECOMMEND trusting the job of connecting refrigerator
BFL5456GB and freezer BFU5456GB to a service agent. But please note that this
job is not included in our warranty service. If you decide to connect these
appliances and prepare them for operation yourself, we recommend getting
someone to help you.
You will need: a screwdriver PH2, a t-type socket wrench No.8 and a wrench No.10. Never lay the
appliances horizontally when connecting them.
Preparing the appliances for connecting
1.
If the appliance is brought in from the cold (temperature is not higher than +12 °C), you
should wait for two hours before connecting it to the mains.
2.
The appliance should not be connected to the mains until all packing and transport materials
aren't removed.
3.
Unpack the appliances. Take them off the polystyrene bases. Remove all the packing tape.
4.
When placing the appliances into their designated place, slightly tilt them backwards: the
wheels at the back will allow you to easily put them into the desired place.
Never lift or push the refrigerator and freezer holding their handles as they may break.
5.
Remove the red tape: it is intended for transportation only.
6.
Appropriately dispose of the packaging.
7.
Take supports 1 out of the bag and insert them into slots 2 at the
top of the back of the appliances (see pic.).
8.
Place the refrigerator and freezer about 1 metre off the wall they
will be placed by. Place the appliances side by side, with the
freezer on the left and the refrigerator on the right.
9.
The component parts necessary for connecting the two appliances are packed with the freezer:
T H E M F O R O P E R A T I O N
front strip 1 (Qty: 1) - attached to the back wall of the freezer, behind its
condenser;
top strip-cover 2 with a sticky base (Qty: 1) (in the bag inside the
freezer);
bottom cover 3 (Qty: 1) - (the bag is attached to the
freezer condenser);
Tabla de contenido
