Festo HMP KP Serie Instrucciones De Utilizacion página 20

HMP−...−KP−...
9. Move the piston rod into the fully extended
end position again.
10. Push the washer 4 between the front
plate and the front cover onto the thread
of the clamping rod.
11. Push the front plate against the clamping
rod by hand until the thread of the clamp
ing rod is fully inserted in the through
hole (Y) in the front plate.
12. Apply Loctite 242 (to prevent unintended
loosening in operation) to the inner thread
of front bearing 3.
13. Push the front bearing into bore (Y) of the
front plate and tighten the thread of the
clamping rod with a hexagon socket screw
key. The tightening torque is 1.5 Nm. The
clamping rod must be countered above
the key flat 5 in this process.
Fitting the pneumatic components
Screw the plug connector 7 into the M3
S
connecting thread 6 on the clamping
unit.
Connect the tubing of the HMP−...−KP
S
clamping unit as follows:
1. Calculate the required length L of the
plastic tubing.
Length (L) is derived from the sum of:
the 0−stroke (see the following table)
and
the stroke length of the linear module
(third figure in product code number).
20
4
Fig. 14
5
(Y)
3
Fig. 15
6 7
Fig. 16
Festo HMP−...−KP−... 0408b English
3