Assembly; Tools Required; Carton Contents; Operation - Powermate PWSTMEA Manual Del Operador

Assembly

(CONTINUED)
• Save all instructions

TOOLS REQUIRED:

• L shaped 5 mm hex wrench (supplied)
• One adjustable or 10 mm wrench
• Phillips screwdriver
A
Edger Assembly
NOTE: Refer to Figure 1-3 when following steps below:
1 . Install the end of the splined shaft and tube containing the small hole into the
gearbox housing . Align the shaft and tube .
2 . Push tube into the gearbox housing and align tube hole to threaded hole in housing .
(See Fig . 1)
3. Using a Phillips screwdriver, install screw into threaded housing hole until the screw's
head contacts the housing surface . Do not overtighten . (See Fig . 2)
4 . Using the provided hex wrench and a 10 mm or adjustable wrench, tighen clamp
screw to secure the tube to the gearbox housing . (See Fig . 3)
B
How to Install the Edger Attachment
NOTE: Refer to Figure 4-6 when following steps below:
1 . Install the Edger attachment into the clutch housing with the metal saddle engaging
the clutch housing . If the unit will not fully insert into the housing opening, turn the
edger blade slightly by hand . This will help align the shaft-to-engine splines .
(See Fig . 4-5)
2 . Screw the camlock inward and rotate the handle to clamp the tube to the housing .
Try to rotate the tube within the housing . If you can rotate the tube at all, unlock the
camlock handle and screw inward an additional one half turn . Rotate the handle to
clamp the tube . Recheck the tube tightness and repeat if necessary . (See Fig . 5)
3 . Depress the finger control on the right upper handle . By depressing the finger control,
the head becomes unlocked and can be swiveled up to 30 degrees . Upon release of
the finger control, a pin will lock the Edger into the desired position . Swiveling the
Edger to the right, positions the Edger to the (right) side and allows the blade
to cut straight in the direction of travel . (See Fig . 6)

Operation

• Save all instructions
A
Before Starting the Engine
WARNING
Before starting engine, read operator's manual. Become familiar with location and function of all controls. Know how to
stop the engine quickly .
1 . Unit has been assembled and installed according to all instructions .
2 . Unit has been inspected for any damaged or missing components .
Questions? Call Toll Free at 1-800-737-2112

CARTON CONTENTS:

• Edger attachment
• Edger operator's manual
• Shaft and tube assembly
• Phillips head screw
• L shaped Allen wrench
EN-6
Copyright © 2018 MAT Engine Technologies, LLC
TUBE
Fig. 1
HOUSING
HOLE
Fig. 2
CLAMP
SCREW
Fig. 3
SHAFT
SPLINES
EDGER
ASSEMBLY
Fig. 4
CAMLOCK SADDLE TUBE
Fig. 5
CLUTCH
HOUSING
FINGER
Fig. 6
CONTROL