Troubleshooting; Technical Service - Powermate PWSTMEA Manual Del Operador

Troubleshooting

• Save all instructions
PROBLEM
Excessive vibrations/noise
Blade will not rotate
Blade rotates when engine is at
idle speed
Blade will not cut properly
Frequent engine stalling
Drive shaft separates from
attachment

Technical Service

• Save all instructions
You may have further questions about assembling, operating, or maintaining this Edger . If so, you can contact our
Technical Service Department at 1-800-737-2112 (English only) . You may also write to:
(Correspondence only)
MAT Engine Technologies, LLC
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (include copy of receipt for written requests)
If you need assistance or have any questions,
CALL TOLL FREE: 1-800–737-2112
Questions? Call Toll Free at 1-800-737-2112
POSSIBLE CAUSE(S)
1 . Loose parts
2 . Bent blade
1 . Debris interfering with blade
2 . Blade loose
1 . Engine idle speed too fast
2 . Clutch not functioning properly
Damaged or worn blade
Excessive edging speed/depth
Drive shaft can become separated
from attachment without harm
to product
EN-10
SOLUTION(S)
1 . Tighten all fasteners
2 . Replace blade
1 . Remove debris from around blade
2 . Tighten blade nut
1 . Adjust engine speed to specifications
2 . Contact Service Dealer
Replace bladet
1 . Edge at a moderate pace
2 . Make multiple passes increasing the depth
slightly each pass
Reassemble drive shaft to unit . Assure
splines line up when installing
Copyright © 2018 MAT Engine Technologies, LLC