Extension Cords - GYS HAND-DUCTION Manual De Instrucciones

Translation of the original instructions
D. Fire Hazard Safety Rules
E. Tool Use Safety Rules
14
HAND-DUCTION

EXTENSION CORDS :

If an extension cord is necessary, only the following two cord lengths are authorized for use
with the HAND-DUCTION :
25 foot, 14-AWG;
50-ft, 12-AWG.
 Use only one extension cord at any one time.
 Do not connect two or more extension cords in series with each other.
 Do not use any other extension cords except those specified above. Unwrap extension
cords — tightly wrapped extension cords can overheat and cause fires.
Do not attempt to heat aerosol cans, paint cans, or any pressurized containers used for
storing fuels, compressed gases, and liquids. The heat generated by the HAND-DUCTION can
cause these containers to explode and their contents to ignite.
Do not use any heating coil if insulation has been breached. If insulation has been breached
it will cause sparking when contacting with a vehicle. This will be a fire hazard especially
when working on or near gas lines and/or gas tanks.
Do not leave the HAND-DUCTION unattended when it is ON. Unplug when not in use.
Make sure that the Power Unit has a sufficient supply of air for cooling. Make sure that the
vents of the HAND-DUCTION Power Unit are clean and free of dust and debris so that the
Power Unit has an unimpeded flow of cooling air.
Do not attempt to repair or service the HAND-DUCTION. There are no user-serviceable parts
except for replacing the coil attachments.
Before plugging in the HAND-DUCTION, make sure that the outlet voltage supplied is
compatible with the voltage marked on the nameplate within 10%. An outlet voltage
incompatible with that specified on the nameplate can result in serious hazards and damage
to the HAND-DUCTION.
Do not twist or bend electrical cord sharply, or damage to internal wiring may result.
Do not use the HAND-DUCTION longer than the duty cycle. The circuit board has an overheat
protection device for protection, however the electrodes (10) do not have overheat protection.
Duty cycle: two minutes on two minutes off.
If the supply cord is damaged, it must be replaced by the manufacture, it service agent or
similar qualified persons in order to avoid hazard.
EN