Ledi ® Reverso Model: Mains Current/Time Code/Display; Impulse Receiver And Afnor Nfs 87500 Time Code Receiver Versions; Radio-Synchronized By Tdf, Dcf Or Gps Versions; Ascii Rs232 Or Rs422 Version - Gorgy Timing LEDI Guia Del Usuario

3.2. LEDI REVERSO MODEL: MaInS CURREnt/tIME CODE/DISPLaY
®
► Connect the 230 VaC 50-60Hz mains to the twin-lead cable.
Connections are made directly on the cables outside the bracket without having to open
the case.
► to access the pushbuttons and the start switch, unscrew and gently push down the
hatch on the bottom of the case.
► after connecting the clock, put the switch on "ON".

3.2.1. Impulse receiver and aFnOR nFS 87500 time code receiver versions

► Connect the cable to the output CODE of the master clock (no polarity).

3.2.2. Radio-synchronized by tDF, DCF or GPS Versions

► No wiring required.
☛
To position your antenna, please refer to instructions on antennas
CDG020/021 or web site www.gorgy-timing.fr section user manual.

3.2.3. aSCII RS232 or RS422 Version

► Connect the cable to the output tXD, RXD & GND of the master clock.

3.2.4. SMPtE version

► Connect smPtE code on the terminal marked CODE of the terminal plug (no polarity).

3.2.5. Version ntP

► Connect the Ethernet wire on the Ethernet outlet available on the item.

3.2.6. tOP option

► Connect the cable on the both wires outgoing from the clock: brown wire and white
wire
► static relay output: no polarity
► ttL 50 ohms output: brown wire is GND, white wire is positive impulse
► sine wave output 1000Hz: brown wire is GND, white wire is frequency

3.2.7. aSCII RS232 or RS485 output option

► Connect the cable marked tXD, RXD et GND on the entry of the material (master
clock, the other clock, PC, etc.)
60
usermanual "MDE-ANTENNES-0085" available on:
MDE-LEDI-1099V3.2