Stagnoli H230 Manual Del Usaurio página 28

those of regulated functions and reset the factory settings, enter the menu
GB
cella
(cancel), go to
ENTER. The message
parameters is confi rmed or the operation is cancelled. The default parameters
ttca=10, t m1=120, aped=70, rlap=0, rlch=0, senc=50, fm1a=5, fm1c=5,
are:
brak=5, trel=2, tdec=1, da=1, ca=1, ba=0, bp=0, cr=0, 2p=0, pl=0, sv=0,
re=0, fcm=0, en=0, ss=0, oc=0, it=0, 2b=0, cf=0, al=0.
cancella 1 radiocomando
•
enter the menu
do
(cancel 1 radio control) on the display and press ENTER. The message
(PRESS) will appear. Now press the transmitter key that must be cancelled. If the
operation has been done correctly, the message
been done correctly, the message
cancella tutta memoria radio
•
recorded transmitters, enter the menu
cancella tutta memoria radio
ENTER. The message
recorded codes is confi rmed by pressing ENTER or the operation is cancelled by
keeping the same key pressed for longer.
N.B: To cancel the memory of the receiver, it is neccessary to confi rm twice the
cancellation (
Language
The display is available in two languages:
To select the chosen language go to the menu
italiano
Go to
Learning
This operation allows the automation to automatically establish the start and end
of a stroke. Before proceeding with this operation ensure that the gate has been
installed correctly and strongly and that the
activated (Stagnoli supplies the station with this function already activated).
When the wording
TER.
Operating with encoder: the fi rst two manoeuvres help to identify the start and
end of the stroke of the motor, the two that follow detect the speed of the motor
when the gate is closing and opening. In this phase, monitor the values shown
on the display. Set the
values read (if the
encoder).
Operating without encoder: the motor undertakes two manoeuvres during which
the time required to complete a stroke is calculated.
Should consumption be shown to be excessively high, check that there are no are-
as where the gate has greater friction. If the operation has been done correctly,
the message
will appear.
WARNING: during learning manoeuvres the station will ignore START AND PEDE-
STRIAN commands and will work with the force parameters that have been set.
28
reset parametri
RESE
is shown, it fl ashes until the decision to reset all the
(cancel 1 radio control)= to cancel a transmitter code,
cancella
(cancel), then go to the wording
(cancel all radio memory) on the display and press
PRG
will appear, it fl ashes until the decision to cancel all the
cancella tutta memoria radio
english
or and confi rm by pressing ENTER.
apprendimento
senc
regulating values so that they are greater than the
senc
value is low, it indicates the increased sensitivity of the
OK
will appear. If this has not been done correctly, the message
(reset parameters) on the display and press
OK
ERR
will appear.
(cancel all the radio memory)= to cancel all the
cancella
(cancel), then go to the wording
PRG
and
italian
and
lingua
en
function of the station has been
(learning) appears on the display, press EN-
cancella 1 radiocoman-
will appear. If this has not
).
english
.
(language) and press ENTER.
can-
PREMI
ERR