Samoa 366 000 Guía De Servicio Técnico Y Recambio página 2

The meter can be connected to a control gun or
installed directly in the distribution line pipe.
It is recommendable to install a cut-off valve before the
meter to facilitate its maintenance or repair.
The meter has a 1/2" BSP connection at the inlet and
outlet.
It also includes an inlet flange and a flange at the outlet
The meter shows the charging status of the batteries
on the display.
BATTERIES OK
2
836 826 R. 09/14
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Installation
with seating for an O-ring seal which enables connection
for the range of guns and original Samoa accessories.
The meter requires two 1.5 V batteries and size LR 03 as
the power supply source. They are housed in a support
which, in conjunction with the lid design, prevents the
batteries from being removed accidentally in the event
of impacts or vibrations.
Batteries
The location of the batteries is shown in the following figure:
o
When replacing the batteries the monitor briefly
displays the meter software version.
Charging status of the batteries
If the meter does not switch on when pressing the ON/
RESET button, or switches off after being pressed,
replace the batteries with new ones.
BATTERIES HALF CHARGED
WARNINGS
bserve The polariTy indicaTed on The baTTeries when insTalling
r
emove The baTTery proTecTive label before fiesT use
BATTERIES EMPTY
REPLACE THE BATTERIES
.
.