Table of contents
Startup
on page 13
Specifications
Specifications are subject to change without notice.
Specification
Dimensions (W x D x H)
Enclosure
Sample (wetted) components
Weight
Installation category
Pollution degree
External power supply
Auto sampler power supply
Operating temperature
Storage temperature
Altitude
Relative humidity
Certifications
Warranty
General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Operation
Details
36.6 x 53.7 x 45.7 cm (14.4 x 21.2 x 18.0 in.)
Aluminum alloy, chromated with an epoxy powder layer
Polyetherimide (PEI) and Polytetrafluoroethylene (PTFE)
21 kg (45 lb)
Auto sampler: I
II
Input: 100-240 VAC, 47-63 Hz, 1.9 A
Output: 24 VDC, 3.33 A
Input: 24 VDC, 3.33 A. Use only with the supplied power supply.
10 to 30 ºC (50 to 85 ºF)
0 to 55 ºC (32 to 131 ºF)
3048 m (10,000 ft) maximum
0 to 95% non-condensing
CE mark
1 year (EU: 2 years)
N O T I C E
on page 13
English 3