Baby Jogger city mini 2 Manual Del Usaurio página 12

FRAME
EN
1 Unpack the stroller frame from the box
and set the wheels aside.
Unlock the stroller by pulling the auto-
lock lever.
2 Unfold the stroller by pulling the
handlebar away from the frame. The
stroller will lock into place and you will
hear a click.
3 Place the stroller in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay stroller on its back so the
handlebar is resting on the floor.
• Attach the front wheel by sliding it into
the front wheel mount until it clicks.
Gently pull on the front wheel to make
sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount.
SWIVEL FEATURE
6 Push the swivel lock button down to
lock the front wheel to a fixed position.
7 Press the swivel lock button up to allow
the front wheel assembly to swivel.
WARNING: When loading and
unloading child, lock the front wheel
in a fixed position. Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame and
insert it into the wheel mount until it
locks into place. You will hear a click.
• Gently pull on the rear wheel to make
sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
BRAKE
10 To lock the brakes: push the brake
lever down to engage the brakes.
11 To release the brakes: lift the brake
lever up.
WARNING:Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
CANOPY
12 Attach the canopy to the frame by
sliding the canopy onto one of two
mounting brackets. To remove, slide
canopy off of mounts.
NOTE: When using a City Go/Graco or
Britax car seat, the canopy must be in
the top position. For all other carseats,
canopy must be removed.
13 Snap the two snaps to the stroller
frame.
14 Zip the back of the seat to the canopy
top. Attach the 2 fastening strips on
teh side of the canopy.
15 Pull forward to open canopy and push
backwards to close canopy.
16 There are two canopy windows, a top
one and back one. To use them, roll
the shade up towards the top and
secure with the elastic and button.
ADJUSTING SAFETY HARNESS
17 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
18 Reinsert stopper at seat opening
closest to child' s shoulders. Pass back
through seat fabric and PE board. Tug
on strap to ensure stopper is locked.
Repeat on both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch
strap in combination with the shoulder
straps and waist belt.
19 Slide the harness pads up to access
plastic guide on strap.
12
EN EN