Mounting Instruction - Chicago Pneumatic CP86150 Manual Del Usuario

EN English
1. Technical Data (See figure 1.)
Dimension
capacity [kg]
A [mm]
B [mm]
C [mm]
F [mm]
E [mm]
F1 [mm]
F2 [mm]
R [mm]
M [mm]
oil
Weight [kg]
max. pressure [MPa]
All values are current as of the date of this publication. For the latest information please visit www.cp.com.
2. Machine type(s)
• The machinery described is intended for machinery production and assembling spare parts. It is used to press, size, assemble, rivet small
parts in process No other use permitted. For professional use only.
• Please read the instructions carefully before starting the machine.

3. Mounting instruction

WARNING
Make sure every parts are fixed and tightened.
• Attach the base section and support to left and right connecting plate. (Fig. 04)
• Assemble the nylon ring to gauge fitting, then put the pressure gauge and twist tight. (Fig. 05)
Remark: twist as tight as possible, otherwise it will be leak. Attach the gauge fitting to the suitable upper cross beam and twist bolt.
• Insert the complete handle into the opening of the lever support, Fig. 03. Assemble pump to the frame. Fig. 07 (CP80015), Fig. 09
(CP80020), Fig. 11 (CP80030 & CP80050).
• Connect the hose and the spring to the lifting device .The white hose is connected under the black hose.(Fig. 04) During moving the machine,
make sure to use the proper lifting equipment and follow the instructions as shows (Fig. 03).
Caution
Working area of 1 m must be kept free both in front of and behind the machine while it is in operation so that it is always
easily accessible.
Purge air from the hydraulic system:
Open the release valve by turning it counterclockwise.
Pump several full stokes to eliminate any air in the system.
Scale: 1:1 Document Ref: 8940169914_REV: 01 _ 05-2012
4. Operation
Caution
Ensure table at proper position and lock the table by 4 pins firmly. (Fig.15)
• Close the release valves, by turning it clockwise.
• Pump the handle/foot pedal until serrated saddle nears workpiece.
• Align workpiece and ram to ensure center loading.
• Pump the handle/foot pedal to apply load onto workpiece (see numeration in pressure gauge).
• When work is done, stop pumping, slowly and carefully remove load from workpiece by turning the release valve counterclockwise in small
increments.(must turn with the small angle)
• Once ram has fully retracted, remove workpiece from table.
Scale: 1:1 Document Ref: 8940169914_REV: 01 _ 05-2012
WARNING
The V-block must be used by pair, not by piece!
WARNING
Only one person is allowed to operate the press.
WARNING
Make sure that the operator must wear protective cloth, gloves, safety helmet, shoes and ear protector during operating.
WARNING
To avoid accidents, always be aware of any on-going work on the machine. Also, always stay focused on the job to be
done.
CP86150 CP86200 CP86300
15 000 20 000 30 000
700 740 795
540 700 700
882 1772 1772
120 132 140
500 510 535
157 185 151
457 1175 1031
160 186 160
/ / 200
[l] 0,6 0,95 1,1
75,5 105 166,7
61 69
CP86500
50 000
1030
800
1830
207
730
68
1048
200
245
2,5
298
58 62
CP86150/CP86200/CP86300/CP86500
Hydraulic press