Comfort Glow ES4830 Instrucciones De Instalación Y El Manual De Propietario página 6

On/Off
Thermostat
Flame Intensity
SERVICE INSTRUCTIONS
WARNING: Disconnect power and allow unit to cool completely before attempting any
maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury.
REPLACING LIGHT BULBS
Access the LED lamp through the rear access panel ( see illustration below).
A. Unplug the power cord from the wall outlet.
B. If the stove has been operating, let the stove cool at least 1 hour.
C. Loosen the screws holding the stove back panel to the main body of stove (see Fig.1).
D. Remove LED lamps and replace with 17V-01 (see Fig.2)
E. Place rear access panel back into position and tighten screws. (Do not over tighten).
Required Tools: Phillips
Head screwdriver (not
provided)
ON: Press the power switch
turn on.
OFF: Press the power switch OFF. All functions will turn off.
THERMOSTAT: This knob controls the thermostat that turns the heat on and off to maintain the
desired temperature. Turn the knob to the desired setting. The heat will turn on and off
automatically to maintain the set temperature.
(NOTE: If the room temperature is higher than the thermostat setting, the heater will not
turn on.)
FLAME INTENSITY :
This knob controls the brightness of the flame effect. Turn the knob to the
right (High) to brighten the flame effect Turn the knob to the left (Low) to dim the flame effect.
(NOTE: The ON/OFF switch turns the flame effect on and off. The flame effect will not turn off
unless the power is turned off.)
ON. The power indicator light will glow, and the flame effect will
~ 6 ~