Comfort Glow ES4830 Instrucciones De Instalación Y El Manual De Propietario página 4

ZONE HEATING SAVES!
The concept of Zone Heating is simple. Use High Efficiency heaters to heat the rooms you use most, during the
times you use these areas and turn back the thermostat to your central heating system. To achieve the
maximum benefit it is important to understand your heater and where best to locate it.
Please follow these suggestions:
1. Close doors to areas you do not wish to heat.
2. Locate a outlet along an interior wall if possible. Position the heater so that the warm air can blow
unobstructed across the room towards the exterior walls.
3. Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat loss.
Rapid heat loss will minimize the effectiveness of your heater as it would any conventional type heater.
4. Keep the area around the heater free of obstructions to insure maximum airflow. Keep electrical
cords, drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater
and away from the sides.
5. Avoid locating your heater in high traffic areas or in direct sunlight.
6. Avoid locating your heater near your central heating thermostat.
INSTRUCTIONS FOR POWER
WARNING: Before servicing this heater be sure to unplug heater from wall outlet. Do
not only turn off heater from the main "ON/OFF" switch, be sure to unplug this heater.
This heater is for use on 120 volts only. The cord has a plug as shown in the following figure.
WARNING: This heater has a voltage rating of
120 volts. The cord has a plug as shown in A. An
adapter as shown in C is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The grounding lug extending from the
adapter must be connected to a permanent
ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot
grounded receptacle is available.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE
GROUNDED PLUG.
~ 4 ~