Motor Maintenance - Jofel AA18000 Manual De Instalación

AVE HAND DRYER
Mark 4 points on the wall and drill Ø8mm holes, place the plugs and then fix it
in place the unit using the screws supplied as shown in figure 3.
IMPORTANT:
A multi-pole disconnector with a contact gap of 3 mm must be incorporated into
the installation.
The equipment must be installed at a minimum distance of 0.6 m from distance
from a water point (sink, etc.).
Replace the housing cover in the direction of the arrows and screw on.
Tighten screws A and B in figure 1 firmly.

3. MOTOR MAINTENANCE

This hands dryer has a Universal type motor which uses carbon brushes to work.
These components suffer wear and might be replaced ones consumed, thus the
motor will can't work without them.
Please contact your distributor to get RA4004 spare parts.

D
EN
Pag. 5