Installation And Assembly - Jofel AA18000 Manual De Instalación

EN

2. INSTALLATION AND ASSEMBLY

Unscrew the two screws at points A and B on the left and right of the inlet/outlet
air outlet as shown in the following figure:
To remove the front cover, place the unit in front of you and pull it towards you by
exerting slight pressure on the sides as shown in the following figure:
1. For this hand dryer, there are 2 installation options for the power source are
possible:
a. DIRECT CONNECTION TO THE WALL POWER CABLE. In this case, the cable
must be inserted through the D-port and connected to the panel connection.
b. When the power supply is far away from the unit, use a flexible cable to
connect the power supply to the unit. for the hand dryer, pass it through hole
C in figure 1 and secure it in place to the device's junction box.
Note:
The size of the cable must be 2x1.5mm².
Use a cable that complies with national standards. (Use the HO5RN-F cable).
Pag. 4

A

AVE HAND DRYER
C B