Starrett S1005 Manual De Instruccion página 100

FIG 04A
7. Then INSERTt the blade between the Lateral Bearings of Upper and
Lower Guides until the back edge of the blade touch on the Back Bearing,
fi gures 05A and 05B;
8. POSITION the Blade on Driver
Flywheel;
9. KEEP the Blade positioned on
the points above mentioned;
10. TURN the Lever (Tensioning
of the Blade) 180°counterclockwise
to keep the cutting tool duly tensioned;
11. CHECK if the installation is duly
fi rm and corectly positioned;
12. INSTALL again the Battery in his position. CHECK the installation,
running carefully 2-3 times the machine, to ensure that the Blade correctly
slide on Flywheels and between the Guides;
13. INSTALL again the Back Cover and the Side Handle.
100
S1005
BLADE
TIGHTENING LEVER
(tensioning of the Blade)
CUTIING
DIRECTION
FIG 04B
ENGLISH