Quick Start - Samson AirLine 88x AH8 Manual Del Usuario

Quick Start

Position the AH8 transmitter about 3–12" (8–30 cm) from the front of the CR88x with the
transmitter's IR window facing the IR transmitter on the front panel of the CR88x receiver.
5. Plug receiver into audio system
Note: The AH8 will only accept infrared transmission from the receiver for the
first 10 seconds after the AH8 is powered on. If you need to change the operating
channel, the AH8 must be first powered off, then powered on again to receive the
new channel.
When the transmission is complete, the
CR88x will receive RF signal from the
transmitter. The READY indicator will light
on the front panel of the CR88x receiver.
Turn on your connected amplifier or mixer, but keep
the volume all the way down. Set the Volume knob
on the CR88x fully clockwise (to its "10" setting).
This is unity gain.
Speak or sing into the microphone and slowly raise
the volume of your amplifier or mixer until the
desired level is reached.
If you find the system has noticeable dropouts,
reduced overall working range, or unexpected noise
bursts, change the operating channel of the system
using the steps above.
8
9. Press and hold SELECT button to IR set
6. Press Select button to change
10. Adjust Volume control