Emptying The Dust Drum; Blowing Feature - Stinger WD20200 El Manual Del Propietario

SP6924 2 GALLON Stinger ESF.qxp_SP6568-2 Stinger.qxd 6/6/14 2:43 PM Page 9
Operation (continued)
Emptying the Drum
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.

Blowing Feature

Your Vac contains a blowing feature. It has
the capability to blow sawdust and other
light debris out of garages or off patios and
driveways. Follow the steps below to use
your Vac as a blower.
1. Locate blowing port of your Vac.
2. Insert one end of the 4 foot x 1-1/4 inch
hose into the blowing port.
3. Turn Vac "ON" and you are ready to use
your Vac as a blower.
1. Place Vac squarely on a stable surface,
such as ground, floor, bench, etc.
2. Remove the power head assembly of
the Wet/Dry Vac by pulling outward on
the latches located on each side of the
Vac. Lift off the power head assembly.
3. Dump the drum contents into the proper
waste disposal container.
WARNING: Always wear safety
goggles complying with ANSI Z87.1
(or in Canada CSA Z94.3) when using
as a Blower.
WARNING: To avoid injury to
bystanders, keep them clear of
blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
9