Kitchen Aid 5K45SS Manual De Instrucciones página 19

TO ATTACH BOWL
• Be sure speed control is OFF.
• Place bowl lift handle in down position.
• Fit bowl supports over locating pins.
• Press down on back of bowl until bowl
pin snaps into spring latch.
• Sit pouring shield on bowl.
• Raise bowl before mixing.
NOTE: Check that bowl and pouring shield
are properly in place (5KSM5 models).
TO REMOVE BOWL
• Place bowl lift handle in down position.
• Grasp bowl handle and lift straight up
and off locating pins.
TO RAISE BOWL
• Rotate handle back and up until it snaps
into the locked vertical position.
• Bowl must always be in raised, locked
position when mixing.
TO LOWER BOWL
• Rotate handle back and down.
TO ATTACH FLAT BEATER, WIRE
WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Lower bowl by rotating bowl lift handle
downward.
• Slip flat beater on beater shaft and press
upward as far as possible.
• Turn beater to right, hooking beater over
the pin on shaft.
TO REMOVE FLAT BEATER, WIRE
WHIP, OR DOUGH HOOK
• Turn speed control to OFF and unplug.
• Lower bowl by rotating bowl lift handle
downward.
• Press beater upward as far as possible
and turn left.
• Pull beater from beater shaft.
TO OPERATE CONTROL SPEED
• Speed control lever should always be set
on lowest speed for starting, then
gradually moved to desired higher speed
to avoid splashing ingredients out of
bowl. See "Speed Control Guide."
R-7