Fluke 1550C Manual Del Usurario página 33

To connect to the circuit under test:
1. Move the safety shutter to access the input terminals.
2. Put the test leads into the correct terminals shown, see Figure 9.
3. Connect the test leads to the circuit under test.
1
3
(-) Negative Terminal

(+) Positive Terminal

Safety Shutter

The Tester is NOT specified below 200 k
shorted and a test is performed, the Tester gives an unspecified
reading that is greater than zero. This is normal for this Testers input
circuitry configuration and does not change readings that are in the
specified accuracy range.
Figure 9. Test Lead Connections
Note
Insulation Tester
2
Ω
. When the leads are
Measurements
GHH09.EPS
15