Display; Rear Panel; Spr 4 Stereo Bodypack Receiver; Controls - AKG IVM 4 Modo De Empleo

2.4.2 Display

Fig. 2: LC display on
transmitter front panel.
Refer to fig. 2.

2.4.3 Rear Panel

Fig. 3: Inputs and outputs
on transmitter rear panel.
Refer to fig. 3.
2.5 SPR 4 Bodypack
Receiver

2.5.1 Controls

Refer to fig. 4.
28
2 Description
1 2
The display indicates all operating parameters of the transmitter:
1 Compressor and limiter gain reduction.
2 Menus for frequency, transmitter name, input gain, audio processing, system
settings.
3 Submenus for Preset (country code), Frequency Group, Subchannel, RF output.
4 OFF (red): Indicates the transmitter is off the air.
5 LOCK mode label (red): goes out in SETUP mode.
6 Alphanumeric display.
7 Audio input level bargraph and red PEAK LED
8 Audio functions: input mode, highpass filter, EQ, room simulation, compressor,
bypass.
In SETUP mode, the currently active setup parameter will be flashing.
1 2
1 ANTENNA: BNC antenna output.
2 AUDIO LOOP L/CH1, R/CH2: These two jacks are connected in parallel to the
AUDIO IN jacks and carry the unprocessed input signal.
3 AUDIO IN L/CH1/MONO, R/CH2: Combined female XLR/1/4" jacks for feed-
ing in a stereo or mono signal. The ?" jacks accept both balanced and unbal-
anced cables.
4 LINE OUT STEREO: This TRS ?" jack provides the processed audio signal. You
can feed this signal to an extra monitor amplifier for floor wedges, etc.
5 DC ONLY: Locking DC input for connecting the included power supply.
6 DATA: Interface for linking the transmitter to a HiQNet network for controlling the
transmitter using a computer and HUB 4000 Q.
The SPR 4 bodypack receiver has been designed specifically for use with the
SST 4 transmitter and IP 2 earbuds. You may, however, connect other earbuds to
the receiver as well.
To power the receiver you can use either the two supplied dry batteries or the op-
tional BP 4000 battery pack from AKG.
1 Headphones output: TRS mini jack.
2 Detented rotary control with integrated on/off switch: Switches power to
the receiver on and OFF and sets the volume of the earbud signal.
3 Permanently attached flexible antenna.
4 Status LED
3
6
3
4
5
7 8
4 5 6
IVM 4