11. Insert the long end of the cable into the front end of the valve. Push the
cable through the valve until the end is through the back of the valve.
12. Insert 2 Packing washers onto the cable, then slide on the
Packing nut behind the washers and tighten.
13. Screw onto the cable the Lock nut and the Adjustment screw. Turn the
Adjustment screw so the end of the cable is level to the top of the slot
in the top of the screw. Tighten the lock nut against the screw.
14. Attach the valve trigger by inserting it into the space between
the Lock nut and Adjustment screw, then insert the Trigger
screw.
15. Screw the Safety lock nut into the valve body, and then attach the
Snap ring.
16. Attach the Nozzle Tip and Cap Nut to the end of the Extension, make
certain the Soft seat gasket is facing correctly. The small end faces the
Extension. Press the Trigger to retract the Seat stem into the Extension,
then attach the Nozzle Tip and Cap Nut.
MAINTENANCE CONTINUED
Use 3/8 Or 7/16
Wrench On
Packing Nut
Packing Washers
Lock nut
Adjustment Screw
Trigger
Insert Trigger
Squeeze Trigger
To Retract Cable
Soft Seat
Long End Of
Cable
Use 2 Washers
With Brass
Packing Nut
Safety
Lock Nut
Snap
Ring
Gasket
Page 8