Kenmore 417.6173 Serie Instrucciones De Instalación página 43

Installation Instructions
Leveling your laundry center
Excessive noise and vibration can be
prevented by properly leveling the laundry
center.
1. With the
laundry center
within 4 feet (1
m) of its final
location, place
a level on top
of the washer lid.
2. Use adjustable
pliers to adjust
the leveling
legs so the
laundry center
is level front-
to-rear and
side-to-side,
and stable corner-to-corner.
3. Press down
on alternate
corners and
sides and feel
for the slight-
est movement.
Adjust the
leg(s) so the laundry center sits solidly
on the floor on ALL four legs. Keep the
leveling leg extension at a minimum
for best performance of the washer.
Connecting inlet water
1. Run some water
from the hot and
cold faucets to flush
the water lines and
remove particles that
might clog the water
valve screens and
to determine which
faucet is hot and
which is cold supply
2. Check to ensure that
the inlet hoses have
the rubber washer
firmly in place.
raise
lower
Rubber Washers
Must Be Present
NOTE
Hoses are not included with laundry
center purchase. See "Accessories" sec-
tion for various inlet hose kits to fit your
specific installation.
3. Connect the
HOT inlet
hose to the
HOT inlet
connection on
the washer
and the COLD
inlet hose
to the COLD inlet connection on the
washer. Tighten by hand until snug.
Then tighten each supply connection
another 2/3 turn with pliers. DO NOT
cross thread or over-tighten these
connections.
4. Connect the
HOT inlet hose
to the HOT
water supply
and the COLD
inlet hose to
the COLD
water supply.
Tighten by hand until snug.
5. Tighten
each supply
connection
another 2/3
turn with
pliers. DO
NOT bend,
kink, or pinch
water inlet hoses.
6. Turn on the water and check for leaks.
19
USE ONLY
NEW HOSES