Tabla de contenido
Idiomas disponibles
Idiomas disponibles
When the Flex Zone or LED lighting is not
working, check the connectors [ ( 1 ), ( 2 )
shown below ] for cracks or leaks.
1. Refer to page 12 for disassembly instructions.
2. Open the cap cover rail with a flat-blade screw
driver.
1
Using the doors
Ensure that the doors close all the way and are
securely sealed.
When the refrigerator door is only partially open, it
will automatically close. If the the door is opened
more than its auto close range, it will remain open.
You must close it manually.
REMOVING THE FREEZER
ACCESSORIES
1. Freezer Room Guard
To remove - Remove the freezer room guard ( 1 )
40_ operating
by lifting the guard up.
To re-install - Push down until the guard ( 1 )
locks into place.
2. Super Extended Drawer
To remove - Pull the drawer out to full extension.
Tilt up the rear of the drawer and lift straight out.
To re-install - Place the drawer onto the rails ( 4 )
by tilting it up. Lower the drawer into place until it
is horizontal and slide the Drawer ( 3 ) in.
2
3
3. Freezer Drawer
To remove the freezer drawer - Pull the freezer
drawer out fully. Tilt up the rear of the bin and lift it
out to remove.
To re-install the freezer drawer - Place the bin
into the rail assembly.
Do not allow babies or children go inside
the freezer drawer. They could damage
CAUTION
the refrigerator and seriously injure
themselves. Do not sit on the freezer door.
The door may break. Do not allow children
to climb into the freezer drawer.
Do not remove the divider.
CAUTION
If trapped inside, children may be injured
or suffocate to death.
WARNING
1
4
Tabla de contenido
