Basic Queue-Based Printing Over Ip; Installing The Axis 5570E - Axis 5570e Guia De Instalacion

Page 28

Basic Queue-based printing over IP

Axis print servers with software version 6.0 or later allow users to print in a Pure IP environment using traditional
queue-based printing (which usually uses the IPX transport protocol). Note that only NDS queue-based printing is
supported.
In the NetWare Pure IP environment, you must use the NetWare Administrator to create the printer, print server and
queue objects.

Installing the AXIS 5570e

Follow the instructions below to install the AXIS 5570e in the NetWare Pure IP environment:
1. Start the Configuration Wizard for General Setup from the User mode in the AXIS 5570e Web interface.
2. Click your way through the Wizard until reaching the NetWare page.
Set the parameters on the NetWare page:
3.
• PSERVER NDS Tree (example: NW5TREE)
or
PSERVER NDS File Server: (example: FILESERVERNAME)
• PSERVER NDS Distinguished Name:
(example: AXISXXXXXX.<context>, where <context> is the container where you want to
create your print server
4. Finish the Wizard.
5. Use the NetWare Administrator to create the printer, print server and queue objects in the NDS tree and then
link them together. The Print Services Quick Setup (Non-NDPS) utility can be used for this. Go to Tools in the
NetWare Administrator.
6. Use the Add Printer Wizard on your work station to install the printer on your client. Note that only NDS
queue based PSERVER printing is supported. When installing, choose Network Printer and browse to the
queue you have just created. Alternatively, choose Local Printer and select the queue you have just captured.
Any configuration and management of the AXIS 5570e can be performed from any standard Web browser. Please
refer to Print Server Management using the built-in Web pages, on page 32.
If both the IPX and IP protocols are enabled in your network and the print server uses DUAL_STACK (enabled by
default) as its network transport protocol, then IPX will be chosen. To force the print server to use the IP transport
protocol, go to your print server's Web interface and choose Admin | Detailed View | NetWare and change the
NetWare Transport Protocol from DUAL_STACK to IP_ONLY. Save and exit when finished.
Note:
Pure IP requires that you run NetWare 5 or higher.
AXIS 5570e Installation Guide