Zone Parameters; Incidences - Airzone FLEXA 3.0 IBPRO6 Guía De Instalación Rápida

ZONE PARAMETERS

•
Associated outputs. It displays and allows you to select the control outputs associated with the thermostat.
•
Thermostat settings. Use this parameter to define the thermostat as Master or Zone.
ES
*Note: It cannot be configured as Master if there is already another Master thermostat.
•
Use mode. The thermostats can be set in Basic or Advanced mode. They are set in Advanced mode by default. These
EN are the parameters you can control in basic mode: On/off, set-point temperature, operating mode (only if this is the
master thermostat) and fan speed.
FR If you need to reset the thermostat to Advanced mode, access the advanced configuration menu and then activate
the advanced use mode.
•
IT Control stages (only available in installations with AZCE6OUTPUT8 modules). This parameter is used to configure both
cooling and heating stages in a single zone or in all the zones. These are the features to be configured:
- Air: It activates the heating/cooling air in the zone.
PT
- Radiant (only in heating stages): It activates the radiant heating in the zone.
DE
- Combined (only in heating stages): It activates the heating air and radiant heating in the zone and lets the user
choose which heating stage to use: Air, Radiant or Combined. The zone will start using the heating air stage. Once
the room temperature reaches the differential preestablished (see parameter Hysteresis Configuration), the zone
will activate the radiant stage.
- Off: It deactivates the cooling/heating stage in the zone.
•
Offset. Correction of the ambient temperature in the different areas of the system mode in both cold and heat.
•
Reset thermostat (not available in remote zones). It resets the thermostat and returns it to factory values.

INCIDENCES

If an error message is shown, you can check both the Installation Manual and the Self-diagnosis section. Please visit Myzone
web: myzone.airzone.es/productos/
30