Sending Data To Us Receiver - Alcad 912-US Serie Manual Del Usuario

SCREEN
5.

SENDING DATA TO US RECEIVER

5.1 Program mode
To program a receiver, turn ON the PROGRAM MODE programming
switch and the programming led will turn on.
programming a single receiver at a time, although it is possible to
program several modules at the same time (see section 6 COPYING
DATA).
ON
OFF
PROGRAM MODE
5.2 Data transmission
Select the desired function on the PS programmer screen and adjust the
right value of that function.
To transmit, press the T key. The programming led will blink to indicate
that the receiver has received the datum.
5.3 Selecting the output channel or output frequency.
WARNING, receivers are adjusted ex works to channel S-41. We
recommend using a previous planning of output channels and a further
noting down in the receiver box before programming, thus avoiding the
selection of already engaged channels. Make sure that the output
channels are not being used in the distribution. Nevertheless, to verify the
output channel programmed in the US receivers that are not properly
noted down, use the READ function.
Serie 912 - US
DESCRIPTION
The data selected does not belong to the range of
values indicated in table 3.
An error occurred during the READ function.
Tab. 4 - Warnings
The programmer will be ready to receive data
from the PS programmer while the led is on.
Once the receiver is programmed, the program
mode must be disconnected by turning the switch
OFF. The programming led will turn OFF.
Fig. 6 - Program mode
ENG - 27
We recommend