Axxess ASWC-1 Manual De Instalación página 7

Section 1: Installation
4) If you are using an Eclipse, Kenwood, Metra OE, or a newer
JVC radio, plug the included female 3.5mm connector with the
Brown and Brown/White wires into the male 3.5mm connector
of the ASWC-1 harness.
• For Kenwood and select JVC: Connect the SWC wire (normally
Blue/Yellow) to the Brown wire of the ASWC-1. Isolate and tape
the Brown/White wire, it will not be used.
Note: Some newer Kenwood radios will auto detect as a JVC. If
this is the case, you can use a 12k-ohm resistor (included) in line
between the Blue/Yellow and Brown wire of the female 3.5mm
jack during programming only. Or you can manually set the radio
type which is in the radio programming section of this manual.
• For Eclipse: Connect the Eclipse SWC wires (normally Brown
and Brown/Black) to the Brown and Brown/White wires of
the ASWC-1. Brown goes to Brown and Brown/White goes to
Brown/Black. Sometimes this is reversed, reverse the wires if
needed.
• For Metra OE: Connect the SWC Key 1 wire (Gray) to the Brown
wire of the ASWC-1.
5) For all other radios, plug in the male 3.5mm connector of the
ASWC-1 into the back of the aftermarket radio, designated for
an external SWC control interface. If in doubt where the 3.5mm
connector of the ASWC-1 goes please refer to the aftermarket
radio manual. Once all connections have been made, plug in the
aftermarket radio if not done already.
7