Seitron DA0411 Manual De Instrucciones página 27

When working with tools in the vicinity of the screw holes, be careful not to
damage the internal electronic circuits.
- Select the operating mode of the device. (See the "OPERATION" paragraph.)
- Connect the device to the relay module, inserting one end of the connection
cable provided on the data connector
marked with the label "SIGNAL IN" on the relay module.
- It is not necessary to connect the external power supply when the device is
connected to a relay module as the latter supplies power through the data
cable.
- If you only use the device as a repeater or receiver connected to a PC, that
is to say not connected to a relay module, it is necessary to connect an
external power supply to terminals 1- and 2+, respecting the polarity. Use a
mains adaptor with direct current output having voltage and output current
as stated in the "Technical data" paragraph.
- Close the device by positioning the cover on the bottom and press down
lightly until the four plastic tabs click.

WARNING
- When deciding on a correct position, make sure that the radio signals
transmitted are received correctly by the receiving unit.
- Device installation and electrical connections must be carried out by
qualified personnel and must comply with the laws in force.
- Before making any connections, make sure the mains power is
disconnected.
WARRANTY
In the view of a constant development of their products, the manufacturer
reserves the right for changing technical data and features without prior notice.
The consumer is guaranteed against any lack of conformity according to the
European Directive 1999/44/UE as well as to the manufacturer's document
about the warranty policy. The full text of warranty is available on request
from the seller.
3
and the other end on the connector
27