Seitron DA0411 Manual De Instrucciones página 24

WARNING:
- The LED will light up for a moment in orange to show that a command has
been received.
- If there is a radio communication problem during the 'self-learning procedure'
it won't be possible to get to the point 3 of the procedure and the LED will
continue to blink orange; after 30 seconds the procedure will be automatically
terminated.
- It is possible to interrupt the procedure pushing again the self-learning key for
a brief moment.
- Repeating multiple times the self-learning procedure, the addresses are added
to the memory in sequential mode, once the 0 channel is learnt, by repeating
the procedure it will be possible to learn the address of the channel 1 and so
on up to the channel 49.
- It's not possible to learn the same address multiple times (on different
channels).
- It's possible to start the self-learning and erasing procedure of one or all the
channels also using the commands via MODBUS®. Through the commands
via MODBUS® it is also possible to force an update of the learnt address of
a specific channel.
Deletion of learnt addresses
When it is desired to erase a learnt address in order not to manage the
corresponding transmitters anymore, there are two possibilities: erase the last
learnt address or cancel all the memory.
The deletion of one or all of the learnt addresses is possible also via MODBUS®
commands.
In order to delete the last learnt address, press and hold the auto-learn button
(the LED will rapidly flash of orange) until when the LED remains still lit of
red. The cancellation is shown on the LED with a gree-red-green-red sequence.
To delete all of the memory, press and hold the auto-learn button until on the
LED the sequence green-red-green-red appears.
24