Kohler K-99571-TL Manual Del Usuario página 7

3/16"
3. Install the Power Bar
NOTICE: If conduit is used for routing the dimmer switch wiring, attach the conduit to a 4" (102 mm)
square electrical plate and secure the plate over the large central hole of the power bar.
Using a 3/16" drill bit, drill two holes at the marked locations on the finished wall.
Insert the supplied anchors where needed.
Position the power bar on the wall, with the electrical wire pulled through the large central hole.
Verify the bar is level, then secure with two screws provided.
Kohler Co. 7 1292979-2-A