Troubleshooting - Dometic WAECO VT100WiFi Instrucciones De Montaje Y De Uso

VT100WiFi
When connected to the reversing light
➤ Switch on the vehicle's ignition.
➤ Engage the reverse gear of the vehicle.
✓ 6 – 8 seconds after engaging in reverse gear, the transmitter is ready for operation.
➤ Connect your receiving device to the wireless network of the transmitter. Use the
address and the password to do this, which can be found on the transmitter housing.
➤ Start the WAECO VT100WiFi app on your receiving device.
✓ The receiving device displays the camera image.
✓ After three seconds without further action, the receiving device switches to full-screen
mode.
✓ Double-click on the screen to open the control bar.
9

Troubleshooting

Problem
The receiving device
cannot find the
transmitter's wireless
network.
The transmitter's
operating display does
not light up.
The app on the
receiving device has a
black screen.
The app on the receiv-
ing device has a blue
screen but the receiv-
ing device is connected
to the wireless network
of the transmitter.
The receiving device
cuts off during image
playback and displays
a yellow warning
triangle.
EN
Cause
The transmitter does
not work.
The transmitter does
not work.
The green cable is not
connected correctly.
The transmitter is not
receiving a video
signal.
The connection
between transmitter
and receiving device is
too weak.
Suggested remedy
Check the power supply.
Check whether the app responds:
open the control bar by double-
clicking on the screen.
Check the transmitter connection
and function.
Check the camera connection and
function.
Make sure that the antenna of the
transmitter is connected properly.
Check if the vehicle battery is
charged sufficiently.
Troubleshooting
27