Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PRODUCT WARNINGS
Read the Manual! Failure to follow operating instructions could result in death or serious injury. Read &
understand the operator's manual before using the monitor.
Charge the unit slowly. Rapid charging may cause a pressure surge that has the potential to cause an
injury, or damage the monitor.
DO NOT stow or deploy the Severe Duty monitor while flowing. Pressing the stow or deploy buttons
causes the nozzle to move automatically and the water stream may cause damage to equipment or
injury to personnel.
Aim the unit in a safe direction before pumping water through it. (i.e. Away from power lines)
Although the circuit board includes a water-resistant coating, it is important to keep water out of the
control box and logic box. Prolonged exposure to water will cause damage.
The Severe Duty monitor uses current limiting for both the monitor and nozzle. Use only
appropriate Akron Brass Company nozzles.
Make the connection of the vehicle and auxiliary battery the final step.
Replace the identification tags if they should become worn or damaged.
DO NOT exceed the maximum pressure or flow ratings of the monitor. Exceeding these ratings
may lead to an injury or may cause damage to the monitor.
DO NOT install shutoffs on the outlet of the monitor. Shutoffs increase the potential for pressure
surges due to water hammer, which have the potential to cause an injury or damage to the monitor.
The Severe Duty monitor, nozzle, logic box, control box, tether controller, and field adjustable stops
are made for optimal performance. Do not alter in any manner.
The Severe Duty monitor contains moving parts. Keep hand, finger and objects away from pinch points.
Disconnect power and disable flow before maintenance.
Keep all personnel out of the Danger Zone in front of the outlet of the monitor when the water
source is attached. Dangerous flow velocities can cause serious injury.
Not designed for explosive environments.
WARRANTY AND DISCLAIMER
We warrant Akron Brass products for a period of one (1) year after purchase against defects in materials or workman-
ship. Akron Brass will repair or replace product which fails to satisfy this warranty. Repair or replacement shall be at
the discretion of Akron Brass. Products must be promptly returned to Akron Brass for warranty service. We will not be
responsible for: wear and tear, any improper installation, use, maintenance or storage: negligence of the owner or user;
repair or modification after delivery; failure to follow our instructions or recommendations; or anything else beyond our
control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY
STATEMENT, AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICU-
LAR PURRPOSE. Further, we will not be responsible for any consequential, incidental or indirect damages (including, but
not limited to, any loss of profits) from any cause whatsoever. No person has authority to change this warranty.
GENERAL INSTRUCTIONS
• Review the instructions, wiring diagram, component layout and rotational stops diagram before installing this unit.
This unit operates on 12 volt DC or 24 volt DC depending on the unit chosen. All electrical current flows through the
wires. The monitor does not act as a ground.
• For firefighting by trained firefighters only.
• For use with water or standard firefighting foams only. After use with foam, flush with fresh water.
• Do not use the Severe Duty nozzle as a forcible entry tool.
• Drain the Severe Duty monitor and nozzle after use to prevent "freeze damage".
• Ensure that the thread in the nozzle swivel matches the thread on the Severe Duty outlet. Do not over-tighten the nozzle
onto the Severe Duty.
Page 2
Tabla de contenido
