Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A1
Operator 1
A2
Operator 2
5/7
M1+ Operator 1/ M2+ Operator 2
6/8
M1- Operator 1/ M2- Operator 2
● Select the number of operators using F2 (F22: one operator, F21: two operators).
● Confirm gate opening direction of A1 and A2 during system programing (first operation is close),
if does not correspond, change the cable connection M+ and M- of corresponding.
● Programme F1 for operation without encoder or limit switches (F11).
● Adjust the trapping force in accordance with the weight of the gate (parameter F3).
Maximum trapping force during system learning process: please make sure the parameter F3"
Maximum trapping force" is in F3-1 during the open/close programming.
A1
Operator 1
A2
Operator 2
G1/G4 Red cable (motor)
G2/G5 Blue cable (motor)
SW1
Main switch
● Select the number of operators using C0 (C001: one operator, C002: two operators).
● Select the directions using C1 (A1) and C2 (A2).
● Programme C7 for operation without encoder or limit switches (C700).
● Adjust the trapping force in accordance with the weight of the gate (parameter A6).
Turning direction check: after connecting the power and activating any of the key devices, the
gate makes a reset (the display shows rS): the gate closes until it reaches the stopper, assigning this
stopper with the position "gate closed" If it opens instead of closes during the reset, change turning
direction using C1 (A1) or C2 (A2).
10
NC
NO
K5
CO
Electrical connections SMART-D201 (M)
K1
K2
K3
-
+
-
+
-
NC
NO
NC
NO
NC
CO
CO
J4
1
2
3
4
5
6
7
8
Lit+
Lit-
Lat+
M1+
M1-
M2+
M2-
Lat-
Electrical connections VIVO-D203 (M)
A2
LED Azul-Memorización Radio
LED2 Pulsador o Selector de llave
+
-
+
LED3 Fotocélula 1
NO
NC
NO
LED4 Fotocélula 2
CO
CO
J5
9 10 11 12 13 14 15 16 17 18
GND
5V
S1
S2
GND
Lmt1
Lmt2
Lmt3
Lmt4
GND
(-)
(+)
A1
B2
A1
ANT
GND
LED2
LED4
LED3
J3
19 20 21 22 23 24 25 26
DKey
SKey
GND
Ph1 PhVcc
GND
Ph2
PhVcc
VIVO-D203:
VIVO-D203M:
J7
J8
Tabla de contenido
