Solutions To Most Frequent Anomalies - Sima Bali 700 MKNO Manual De Instrucciones Original

12. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALY
Motor does not
start up
Motor starts up
very slowly and
Damaged condenser. (Single phase
takes long to
reach its
revolutions
Bluntness of the blade segments or
Cutting power
insufficient
Water level low in the tray
The cooling water
does not reach
the blade
The pump water tape is closed
Blade premature
damage
The machine is not aligned
Blade deteriorated or worn-out
Defective cutting
Vibrations
occurrence
POSSIBLE CAUSE
Power supply fault
Damaged switch
Blocked blade
motors)
diamond bands
Inappropriate blade
Motor low potency
Pump blocked
Pump damaged
Insufficient cooling
Excessive advance
Inappropriate blade
Inappropriate blade
Blade oscillation
Blade subjection defect
Wrap the blade
SOLUTION
Check the power supply in the switch
board. Check the position of the thermal
magnet and the differential in the switch
board. Make sure the extension cable is in
a good state and well plugged in both
ends
Substitute it
Remove obstacles preventing the blade
from turning
Substitute it
Effectuate different cuts on an abrasive
material (Sandstone, concrete, stone
emery)
Use appropriate blade for material
Let the motor be checked by technical
service
Fill in water to level
Dismount the tape filter and clean it
Substitute the pump
Open the water tape
Check the cooling
Decrease the advance
Use appropriate blade for material
Align
Change blade
Use appropriate blade for material
Check the state of the disc and mount it
correctly
Make sure the bridles and the motor axis
are well adjusted. Tighten well the nut.
Change the blade
16
ENGLISH