Electrical Connections; The First Wash Cycle; Technical Data; Wdd 9640 - Ariston Hotpoint WDD 9640 Instrucciones De Uso

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated on
the Technical Data Plate fixed on the machine;
• the power supply voltage falls within the values
indicated on the Technical Data Plate fixed on
the machine;
• the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace the
socket or the plug.
! The washer-dryer must not be installed outdo-
ors, even in covered areas. It is extremely dan-
gerous to leave the appliance exposed to rain,
storms and other weather conditions.
! When the washer-dryer has been installed, the
electricity socket must be within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with de-
tergent and no laundry, using the cycle "Auto Clean"

Technical data

WDD 9640

Model
width 59.5 cm
Dimensions height 85 cm
depth 54 cm
from 1 to 9 kg for the wash
programme
Capacity
from 1 to 6 kg for the drying
programme
Electrical please refer to the technical
connections data plate fixed to the machine
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05 MPa
nections
(0.5 bar)
drum capacity 58 litres
Spin speed up to 1400 rotations per minute
Wash: programme
rature 60°C (2nd press of the
button); using a load of 9 kg.
Energy ra-
Drying: the smaller load must
ted
be dried by selecting the "EX-
programmes
TRA" dryness level. The load
according to
must consist of 3 sheets, 2
regulation
pillowcases and 1 hand towel;
EN 50229
the remainder of the load must
be dried by selecting the "EX-
TRA" dryness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electromagne-
tic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU - WEEE
GB
; tempe-
3