Network Connection - Tripp-Lite PDUMVR20NET Manual Del Propietário

Installation
Network Service Configuration
The following prompts configure the connection methods the Network Interface will accept.
Enable SNTP? [Y]
Enable FTP? [Y]
Port number? [21]
Enable HTTP? [Y]
Port number? [80]
Enable HTTPS? [Y]
Port number? [443]
You can also change the root password, real-time clock and other settings. (Tripp Lite
recommends against changing the default settings unless you are an advanced user with a
specific purpose.) After you have finished entering settings, the PDU will save changes to memory
and reboot (this may take several minutes). After the PDU reboots, the initialization page should
display the new static IP settings.
4-6
Remove Serial Cable: Remove the serial cable from the PDU and proceed to Step

Network Connection

5-1
Connect PDU to Network: While the
PDU is powered, connect a standard
Ethernet patch cable to the RJ-45
Ethernet port on the PDU.
Note: This port is not compatible with PoE
(Power over Ethernet) applications.
5-2
Test Network Connection: After an IP address has been assigned to the card, try to
access it with a Web browser. Open a supported web browser on a computer connected
to the network and enter http:// or https:// followed by the IP address. The login screen
for PowerAlert Device Manager will display. The default user name is localadmin and the
password is localadmin. After you enter the user name and password, the PowerAlert
Device Manager Overview page will appear in the browser window. For more information
about configuration and operation of the managed device, refer to the LX Platform User's
Guide located in the support section of the product web page.
Note: Supports Internet Explorer, Firefox and Chrome Web browsers.
16-10-211-933668.indb 7
Enable Telnet Menu? [Y]
Port number? [23]
Enable Telnet Programs? [Y]
Port number? [5214]
Enable SSH Menu? [Y]
Port number? [22]
Enable SSH Programs? [Y]
7
Port number? [2112]
Enable SNMP? [Y]
Port number? [161]
Enable SNMPv1? [Y]
Enable SNMPv2c? [Y]
Enable SNMPv3? [Y]
5-1
12/22/2016 11:36:16 AM
.