JANE Balance Manual Del Usuario página 36

the safety seat, make sure that the vehicle seat where you are going to install it is i-Size, or that it is fitted with
ISOfix anchors and that your vehicle is on the list of compatible vehicles.
To make it easier to place the child in the seat, you can turn the seat so it faces the car door. The seat will not
lock in this position, once the child is in the seat the seat should be turned back to the position for travelling.
For babies up to 60 cm in height use the cushion insert.
When using the insert, the headrest of the seat should be in the lowest position. Read section H for instructions
on how to adjust the headrest height.
Place the cushion insert in the seat, passing the shoulder straps through the slot below the headrest.
Fasten the baby in following the steps below:
Pull the lever (13) found on the side of the seat and turn the seat. 3.a
Loosen the integrated belts by pulling the straps (5b) above the buckle while pressing the tightening button (5c).
3.b
3.c
Unfasten the buckle (5a).
Place the child in the seat making sure that they are sitting well back and that their back is straight. Join the top
ends of the buckle. 3.d
Insert them into the central lock and press until you hear them click. 3.e
3.f
Pull the tightening strap (5b).
3.g
Turn the seat to the position for travelling, you don't need to pull the lever.
WARNING:
The forward facing position is not recommended at all for babies of less than 76 cm tall or under 15 months old.
36
EN