Installing Or Removing A Blade; Assembly And Preparation - Evolution EVOSAW 355 Manual De Instrucciones

www.evolutionpowertools.com
(>5.5)
GETTING STARTED - PREPARATION
RELEASING the CUTTING HEAD
The cutting head will automatically rise to the upper position
once it is released from the locked down position.
To Release the cutting head from
the Locked Down position: (5.5<)
• Gently press down on the cutting handle.
• Pull out the head latching pin and lock in the outer position
(Fig. 1) Allow the cutting head to rise to its upper position.
If Release is Difficult:
• Gently rock the cutting head up and down.
• Pull the latching pin fully out and turn 1/4 of a turn to lock in
the outer position.
Note: We recommend that when the machine is not in use the
cutting head is locked in its down position with the latching pin
fully engaged in its socket.
(>5.1)

INSTALLING or REMOVING a BLADE

WARNING: Only use genuine Evolution blades, or Evolution
approved blades which are designed for this machine. Ensure
that the maximum recommended blade speed of the blade is
compatible with the machine.
WARNING: Only perform this operation with the machine
disconnected from the power supply.
Note: It is recommended that the operator considers wearing
protective gloves when handling the blade during installation
or when changing the machine's blade. (< 5.1)
(5.6)
Removing a Blade:
• Ensure that the cutting head is in its upper position.
• Loosen the fastener screw securing the arbor guard and rotate
the guard upwards to reveal the machine's arbor. (Fig. 2)
• Engage the arbor lock by pressing the arbor lock button.
(Fig. 3)
• Use the supplied hex key to loosen the arbor screw. (Fig. 4)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
15
EN
ES
FR