Grohe Eurosmart Cosmopolitan E 36 332 Manual De Instrucciones página 9

Adjustment
For temperature adjustment, see fold-out page I, Figs. [3]
and [4].
• Before the mixer is put into service, if the mixed water
temperature measured at the point of discharge varies from
the specified temperature set on the thermostat.
• After any maintenance operation on the thermostatic
cartridge.
Applying settings
The infrared electronics provide seven preset programmes for selection. Programme 1 is set at the factory.
Programme Temporary
shutoff*
Programme 1 Active
Programme 2 Active
Programme 3 Active
Programme 4 Active
Programme 5 Active
Programme 6 Inactive
Programme 7 Inactive
* Cleaning mode can be activated when temporary shutoff is activated. In cleaning mode, water flow is not started for 3 minutes
even if an object is detected.
** Automatic flushing serves to ensure water hygiene in the event of long-term non-utilisation of the fitting. Flushing is initiated
for a duration of 1, 5 or 10 minutes after 24 hours (usage-independent) or 72 hours after the fitting was last used (usage-
dependent).
Safety note:
Ensure free draining in the case of activated automatic flushing.
The fitting can be individually programmed using the remote control (see Special accessories, prod. no.: 36 206).
1. Start water flow and measure the temperature of the water
using a thermometer, see Fig. [3].
2. Detach temperature control handle (C), see Fig. [4].
3. Turn regulating nut (D) until the water temperature has
reached 38 °C.
4. Install temperature control handle (C) so that button (E)
points towards the front, see Fig. [3].
Automatic flushing**
On/off Flush interval Flush duration
Off -
On 72 h
On 24 h
On 72 h
On 72 h
Off -
On 72 h
Usage-dependent/
independent
- -
5 min Usage-dependent
5 min Usage-independent
10 min Usage-dependent
1 min Usage-dependent
- -
5 min Usage-dependent
Duration
of thermal
disinfection
3.5 min
3.5 min
11 min
3.5 min
3.5 min
3.5 min
3.5 min
6