Accu turn 1200 Manual Del Usuario página 80

80
Installation Instructions
Weight Tray Plane:
• Rest the weight tray plane on the machine and,
before securing it, pass the keyboard connecting
cables to the outside: the cables are fed in from the
bottom of the Weight Tray Plane and exit through
the top, where the keyboard will be positioned.
• Fit the two side screws with metric pitch (1-Fig. iii-
4).
• Fit the two black self-tapping screws on the front
(2-Fig. iii-4).
N.B.: If the Gauge Support Bracket is available, the
screws in question will have different lengths (25
and 32mm).
IMPORTANT! Only use the longer screws to se-
cure the Gauge Support Bracket.
- Position the Bracket (3-Fig. iii-4) over the left
Weight Tray Plane fixing hole.
- Insert the long screw (4-Fig. iii-4) and tighten it
normally on the cubicle.
Control panel:
• Connect the multi-track cable to the connector be-
hind the panel.
• Connect the earth cable to the front panel.
• Apply the Control Panel, angled correctly, carefully
positioned at the centre of its seat on the Weight
Tray Plane.
• Press on the sides to make the Velcro tape adhere
correctly.
Rapid Ring Nut Support Pin:
• Position the rapid ring nut support pin in its seat on
the wheel guard tube (1-Fig. iii-5).
• Fix the pin with the nut.
iv Test procedures.
• Balance a wheel to less than 0.25 oz. per plane.
• Perform a User Calibration. See Chapter 6.3.1.
v Instructing the operator.
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and
off.
• Show the operator how to perform an emergency
stop.
• Show the operator how to select a wheel type, en-
ter data and apply a weight.
Operator's Manual ACCU 1200