Technical Data; Ordering Replacement Parts; Cleaning, Maintenance And Ordering Of Spare Parts - ALPHA-TOOLS PS 600 E Manual De Instrucciones

Anleitung PS 600 E_SPK7

5. TECHNICAL DATA

Nominal voltage: 230 V ~ 50 Hz
Power consumption:
Cutting rate: 500-3200 strokes/min.
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts: up to 45° (left and right)
Sound pressure level LPA: 89,5 dB(A)
Sound power level LWA: 100,5 dB(A)
14,35 m/s
Vibration a w
Double isolation
Weight
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
14.08.2006 9:03 Uhr Seite 7

7. Ordering replacement parts

Please quote the following data when ordering repla-
600 W
cement parts:
Type of machine
20 mm Article number of the machine
Identification number of the machine
65 mm
Replacement part number of the part required
20 mm
For our latest prices and information please go to
www.isc-gmbh.info
8 mm
2
II / ®
2,1 Kg
GB
7