Dry Operation - Haier HSU-09HRA03/R2 Manual De Funcionamiento

Operation

Dry Operation

(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
(2) Select operation mode
Press MODE button. For each press, operation
mode changes as follows:
AUTO COOL DRY
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
Every time the button is pressed, temp. setting decreases 1
Unit will start running to reach the temp. setting on LCD.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
AUTO LO
Unit runs at the speed displayed on LCD.
In DRY mode, when room temperature becomes
lower than temp.setting+2
at LOW speed regardless of FAN setting.
(5)
Unit stop
Press ON/OFF button, the unit stops.
Hints
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next time,
just press ON/OFF button and unit will run in previous status.
No reelecting is needed.(TIMER ON/OFF SLEEP SWING needs reelecting)
HEAT
FAN
MED HI
o
C,unit will run intermittently
11
HEALTH ON/OFF
1
5
FAN
MODE
3
2
SWING
TIMER
CLOCK
SLEEP
SET
o
C
LOCK RESET
o
C
COOL operation starts when room
temp. is higher than temp. setting.
o
Temp. setting+2 C
Temp. setting
On reaching temp. setting, unit
will run in mild DRY mode.
3
Ultra-low air flow