Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GC2e Wireless Security System | User Guide
Disarm with a Key Fob
To disarm the system from Stay or Away mode sing a key
fob, tap the Disarm
button.
NOTE: To use your key fob to disarm your system, this
option must already be enabled by your installer.
Activate the Emergency Alarm
To trigger an emergency alarm using a key fob, press
and hold the Away
button and Disarm
simultaneously for 5 seconds.
NOTE: If an emergency alarm is, triggered by a key fob, it
cannot be stopped using the key fob Disarm button. The
alarm must be canceled at the Control Panel.
WIRELESS KEYPAD: ARMING AND
DISARMING
Your system may be equipped with one or more wireless
keypads. Up to four (4) wireless keypads can be used to
control the system remotely from the main Control Panel.
Two types of wireless keypads are available. A wireless
keypad without a screen, and a wireless touch screen
keypad.
The wireless touch screen keypad operates virtually the
same as the Control Panel. Each standard wireless keypad
has buttons for entering user codes, Stay and Away mode
buttons, and Fire and Police emergency buttons.
Check the See "Installer Programmed Options" on
section in this guide to verify which 24-hour Fire and Police
emergency buttons have been enabled by the installer.
Arm with a Keypad
Stay Mode
To arm the system to Stay mode using a wireless keypad:
1
At the Home screen, tap Security > Arm.
2
Enter a valid user code.
3
Tap the Stay button.
4
If Quick Arming has been programmed by your installer,
just tap the Stay button.
NOTE: If any perimeter door or window sensors are open,
the system does not allow arming to Stay mode with a
wireless keypad. For keypads without a display screen, all
open sensors must be bypassed at the Control Panel first.
Away Mode
To arm the system to Away mode using a wireless keypad:
1
At the Home screen, tap Security.
2
At the Security screen, tap Arm.
3
Enter a valid user code.
4
Tap the Away button.
5
If Quick Arming has been programmed by your
button
installer, just tap the Away button.
NOTE: If any perimeter door or window sensors are
open, the system does not permit you to use a wireless
keypad to arm the system in Away mode. For keypads
without a display screen, all open sensor-protected doors
and windows must either be closed or bypassed at the
Control Panel before arming with a wireless keypad.
Disarm with a Keypad
To disarm the system from Stay or Away mode, enter a
user code.
Activate a Fire Emergency
To trigger an emergency fire alarm using a wireless keypad,
press and hold the Fire button for two (2) seconds.
NOTE: To use a wireless keypad to trigger a fire alarm, this
option must already be enabled by your installer.
Activate a Police Emergency
page
34,
To trigger an emergency police alarm using a wireless
keypad, press and hold the Police button for two (2)
seconds.
NOTE: To use a wireless keypad to trigger a police alarm,
this option must already be enabled by your installer.
17
Burglary Protection
Copyright © 2019 Nortek Security & Control
Capítulos
Tabla de contenido
