Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Sprayheads — Standard w/Neoprene Spray Ring Grommet
NOTE: Repair kit does not include sprayhead
grommet. Order as a separate item.
Parts List
Item
Part No.
1
125-001DE
2
139-031
3
124-001AL
4
160-211
5
115-061
6
116-008
7
124-001AT
8
161-025
9
124-020D
10
125-001DF
Sprayhead Service Suggestions
Problem: Water splashes over the rim of the bowl.
Cause: Foreign matter has reduced the size of the sprayhead slots, causing greater pressure at the open slots.
Solution: Clean the sprayhead:
1. Disassemble the sprayhead and dislodge any dirt, lime build-up and foreign debris with a wire brush.
2. Sprayheads with rubber grommet spray rings may be cleaned by rubbing a coin over the grommet.
3. Throttle down the volume control (water spray should strike the bowl without splashing outside of the bowl).
Problem: Water flow diminishes from the sprayhead.
Cause: Strainer portion of the stop-strainer-check valve is plugged.
Solution: Remove and clean the strainer screen from the stop-strainer-check valve.
NOTE: The sprayhead shown above includes a perforated neopreme spray ring grommet that is self-cleaning. The water pressure flexes
the spray holes which slows accumulation of foreign matter and tends to "break loose" any such deposits that may have accumulated.
Bradley Corporation • 215-1332 Rev. U; EN 10-00-002
1
10
Description
Neoprene Washer-Top
Sprayhead Manifold
Washer
Carriage Bolt
Sprayhead Top
Sprayhead Bottom
Washer
Nut
Sprayhead Grommet - Semi-circle
Neoprene Washer-Bottom
2
4
3
7
8
Sprayhead
Assembly S05-054B
1
1
3
3
1
1
3
3
1
1
1-26-10
TDB3103, WF3203
5
9
6
Repair Kit
S45-051
Qty
1
—
4
4
—
—
4
4
—
1
19
Tabla de contenido
Solución de problemas
