Lights; Shut Down; Troubleshooting - Carson Mercedes Benz UNIMOG U 300 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

m. Lights
GB
The lights can be switched on or off as required. The switch is on the
top right of the transmitter.
n. Shut down
Follow reverse procedure to shut down.
1. Turn off the model.
2. Turn off the transmitter.
• Never touch or hinder rotating tires.
• Never run RC model in the rain or let run over puddles, as water
may cause trouble with the RC model.
• The motor and battery may become hot during operation. Take
care when you handle them.
• Remove the batteries from the model and the transmitter when
they are not in use.
o. Troubleshooting
Problem
Model does not move
No control
24
CARSON Mercedes Benz UNIMOG 50 090 7170
Cause
Transmitter switch and/or model switch is/are off
Weak or no rechargeable batterie/battery in the
model
Heat protector has stopped car due to excess heat
Weak or no batteries in transmitter or model
Cautions when handling batteries/rechargeable
batteries
Only use the supplied battery for the RC model and 8x AA
rechargeable/non-rechargeable batteries for the transmitter.
• Do not recharge abattery that is still warm from use as it may
damage the battery. Allow the battery to cool off prior to
recharging.
• Remove transmitter battery when not using it for a long term as it
may leak and damage the transmitter, when left for a long period.
• Never incinerate used batteries, as they can explode causing
serious accidents.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the model before
being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the model.
• Please check the electronics, cable, body and other parts regularly
for damage.
• Only use the charger supplied!
Remedy
Switch on
Install charged rechargeable batterie/battery
Turn off receiver switch. Let RC model cool down for
approximately 30 minutes.
Install charged or fresh batteries
Tabla de contenido
loading

Tabla de contenido